开关模型

3D模型简介下载收藏预览

this is a new version of the support for a switch if you have mounted the bolted z-endstop. the switch's diameter is 6mm. you need 2 m3 bolt (16 mm long) to connect the support to the z engine(nema17). i have printed it with PLA and Cura. Cura settings: layer height 0.2 shell+top/bottom thickness 1.2 fill density 40% support brim 12 (it's not necessary)

这是一个新的交换机支持版本如果你有安装螺栓z-endstop。开关的直径6mm。你需要2立方米的螺栓（16毫米长）连接支持Z引擎（NEMA17）。我打印了PLA和库拉索。③设置：层高度0.2壳+顶部/底部厚度1.2的填充密度40%檐12（不是必须的